Description

Wood Spigot for Continuous Brew Barrel Vessel

This type of spigot 100% natural wood. Fits hole size 3/4 inches.

Installing The New Spigot

Test the spigot first by firmly grasping the body in one hand, and with the other hand use consistent pressure to twist it open and closed. It might feel tough to move at first, but it will not break.

Insert the spigot using a mallet, or place a cloth over the spigot and gently hammer it in until the knuckle is flush of just about flush with the side of the barrel.

Cleaning The Spigot

Sometimes yeast or bits of SCOBY may collect inside the spigot and clog up the flow. This is perfectly normal but can be frustrating. Rather than having to take the whole assembly apart every time this happens, simply dislodge them with the FREE spigot brush included with every KKamp spigot. If you did not order a spigot from Kombucha Kamp, you can try using a toothpick or something similar to dislodge the blockage.

When it is truly time to clean the spigot, or if it proves too difficult to remove a blockage, drain the vessel and allow then remove the spigot and run under clean, hot water which should flush the items. When unattached, it may also be easier to pick out any remaining yeast or SCOBY.